• CNC-Machined stainless-steel
• Pre-drilled head for race wire
• SINGLE LENGTH for use with one banjo fitting
• Choose M10x1.0 (fine thread) or M10x1.25 (coarse thread)
• Includes 2 annealed copper crush washers
• Made in the USA
• Sold each

This CNC-machined stainless-steel Race Spec banjo bolt has a pre-drilled head for race wire. The term "single length" means it will work with 1 single banjo fitting. If needing to pass through 2 banjos fittings, please choose our double length banjo bolt listing. Each bolt includes annealed copper crush washers for leak-free installation. Bolts are sold each.

In general, but not in all circumstances, the following thread pitch guide applies:

• OEM Japanese brake system components use M10x1.25
• OEM European brake system components use M10x1.0
• Aftermarket brake system components, such as Brembo or Galespeed, generally use M10x1.0

OEM-Installed Brembo brake system components:

• Actual thread pitch may vary, depending on model
• European bikes generally use M10x1.0 OE Brembo parts
• Japanese bikes generally use M10x1.25 OE Brembo parts
• PLEASE CHECK YOUR OEM THREADS BEFORE ORDERING AS THERE ARE A FEW EXCEPTIONS TO THIS RULE